LD2000-P

AC CONTROLLER

INSTALLATION INSTRUCTIONS
CHANNEL SELECTION & TIMING
TROUBLESHOOTING

 

4 x white PIR + AC controller
The LD2000-P is an AC controller designed for switching mains power for lighting.


CONNECTING A SINGLE LOAD AND UP TO FOUR PIR SENSORS
1. Connect 240V load to Load A terminals.
2. Connect 240V power to AEN terminals.
3. Push LHS DIP switch down for single channel mode.
4. Plug in the first PIR sensor to Sensor Input 1.
5. Repeat for additional PIR sensors using Sensor Inputs 2, 3 & 4.
6. Important: The jumpers are to remain on any unused sensor inputs.
7. Set time delay using the three RHS DIP switches as in the diagram below.

CONNECTING TWO INDIVIDUAL LOADS AND UP TO TWO PIR SENSORS PER LOAD
1. Connect first 240V load to Load A terminals
2. Connect second 240V load to Load B terminals.
2. Connect 240V power to AEN terminals.
3. Push LHS DIP switch up for two channel mode.
4. For Load A: Plug in the first PIR sensor to Sensor Input 1.
5. Connect a second PIR sensor to Sensor Input 2 or if none leave the black jumper on.
6. For Load B: Remove the black jumper on Sensor Input 3 and connect the first PIR sensor.
7. Connect second PIR sensor to Sensor Input 4 or if none leave the black jumper on.
8. Important: The jumpers are to remain on any unused sensor inputs.
9. Set time delay using the three RHS DIP switches as in the diagram below.


CHANNEL SELECTION & TIMING

LD2000-P connections, timing diagram

POWER
Solid-state switching of mains power with a maximum total load connected to all outputs of 500W.


TROUBLESHOOTING

    • Is there a jumper on all unused Sensor Inputs?
    • Remove plugs and reinsert.
    • Check load by connecting directly to power.
    • Check the tables above for the correct configuration.
    • If problems persist phone or email for technical support. www.lightdream.com.au

SPECIFICATIONS
LD2000-P
Input/Output: 240VAC 50Hz
Power outputs: 2
Maximum Load (total): 500W
Switching Method: Solid-state
Touch sensor inputs: 4
Timer settings (8):10s, 30s, 1m, 5m, 10m, 15m, 30m, test
Controller dimensions H: 35mm, W: 56mm, L: 153mm
EMC AS/NZS CISPR14.1:2010
Electrical Safety AS/NZS 61558; AS/NZS 3820:2009
Flammability ABS AF312C-NP 94VO