LD2000-T

AC CONTROLLER

INSTALLATION INSTRUCTIONS
CHANNEL SELECTION & TIMING
TROUBLESHOOTING

 

The LD2000-T is an AC controller designed for toggling outputs using devices such as touch sensors, wireless dongles or push buttons. Any combination of these devices can be used. Time delay can be set to turn off the controller from 10 seconds to 30 minutes if left on.


CONNECTING A SINGLE LOAD USING ONE TO FOUR INPUTS
1. Connect 240V load to Load A terminals.
2. Connect 240V power to AEN terminals.
3. Push LHS DIP switch down or ‘Off’ position for single channel mode.
4. Plug in the first touch device to Sensor Input 1. For a push button plug into the two RHS pins
5. Repeat for additional devices using Sensor Inputs 2, 3 & 4.
6. Important: The jumpers are to remain on any unused sensor inputs using the two RHS pins.
7. Set time delay using the three RHS DIP switches as in the diagram below.

CONNECTING TWO INDIVIDUAL LOADS WITH ONE OR TWO INPUTS  PER LOAD
1. Connect the first 240V load to Load A terminals
2. Connect the second 240V load to Load B terminals.
2. Connect 240V power to AEN terminals.
3. Push LHS DIP switch up or ‘On’ position for two channel mode.
4. For Load A: Plug in the first device on Sensor Input 1. Connect a device to Sensor Input 2 or if none, leave the black jumper on.
5. For Load B: Remove the black jumper on Sensor Input 3 and connect the first device. Connect the second device to Sensor Input 4 or if none, leave the black jumper on.
6. Important: The jumpers are to remain on any unused sensor inputs using the RHS two pins.
7. Set time delay using the three RHS DIP switches as in the diagram below.


CHANNEL SELECTION & TIMING

LD2000-T timing

TOUCH SENSORS
L28 * W15 * D6mm

POWER
Solid-state switching of mains power with a maximum total load connected to all outputs of 500W.


TROUBLESHOOTING

    • Is there a jumper on all unused Sensor Inputs?
    • Remove plugs and reinsert.
    • Check load by connecting directly to power.
    • Check the tables above for the correct configuration.
    • If problems persist phone or email for technical support. www.lightdream.com.au

SPECIFICATIONS
LD2000-T
Input/Output: 240VAC 50Hz
Power outputs: 2
Maximum Load (total for both outputs): 500W
Switching Method: Solid-state
PIR sensor inputs: 4
Timer settings (8):10s, 30s, 1m, 5m, 10m, 15m, 30m, test
Dimensions H: 35mm, W: 56mm, L: 153mm
EMC AS/NZS CISPR14.1:2010
Electrical Safety AS/NZS 61558; AS/NZS 3820:2009
Flammability ABS AF312C-NP 94VO