LD2052 DC CONTROLLER
FOR TOUCH SENSORS & WIRELESS RECEIVER MODULES

  • DIMMING
  • 4 TIME DELAY SETTINGS
  • FADE-IN/FADE-OUT

LD2050 LUX and PIR controller

INSTALLATION INSTRUCTIONS & TROUBLESHOOTING

OPERATION

The LD2052 is used with Lightdream’s touch sensor or wireless receiver dongle LD2083. The output flip flops with each change on the input. If there is no further change, the timer can time out. The timer can also be set to infinity so that only another input change will turn off the output.

CONNECTING POWER
1. Slide off the terminal cover.
2. Connect power either by:
a) plugging in a 12/24VDC power adapter
OR
b) hardwire directly from a 12/24VDC LED driver to the screw terminals marked “INPUT”.
3. Connect the LED strip using the screw terminals marked “OUTPUT” (5A maximum load).

CONNECTING THE SENSORS 
Plug the touch sensor or wireless receiver into either one of the two sensor inputs.

DIMMING
If light is too bright, slide off the terminal cover and adjust the dial to suit the required light level.

TIMER SETTINGS
The two DIP switches set the time delay to turn off the light when there is no further triggering. Time settings are 15s, 30s, 1m, 2m.
If re-triggered prior to timing out the timer restarts from zero.
To set, slide off the connection cover and set the DIP switches as follows.

 

timer setting for LD2050


TROUBLESHOOTING

  • Is the polarity correct for input and output power?
  • Connect the LED light directly to the power supply and check if working and the correct polarity.
  • To test the controller, disconnect all sensors and place using a screwdriver short the two LHS pins of either sensor input. The light should now be on.
  • Contact Lightdream Technical Support by phone while on-site if you require additional assistance.

SPECIFICATIONS
Designed for 12/24V LED lighting
Voltage: 12/24VDC
Load current (max): 5A
Maximum load: 60W @ 12V, 120W @ 24V.
Sensor inputs: 2
Dimming: 0-100%
Timer: 15s, 30s, 1m, 2m