LD2080
WIRELESS DOOR SWITCH FOR USE WITH LD2045/LD2046/LD2000-P CONTROLLER
INSTALLATION
1. Insert 2 X CR2032 coin batteries (+) side up into the transmitter.
2. Plug the receiver dongle LD2083 into one of the LD2045/LD2046/LD2000-P controller’s inputs.
3. Connect the controller’s power input and output load.
4. For a two door cabinet attach the transmitter to the inside of one door and the magnet to the inside of the other door so that both parts are within 30mm of each other.
5. For a single door place the magnet on the inside of the door and the transmitter on the carcass interior so that both parts are within 30mm of each other.
6. Magnet is fixed adjacent to the side of the transmitter as indicated by the arrow.
SETUP
1. Units are usually programmed but if not close the doors or place magnet next to transmitter to switch it off.
2. On the receiver dongle press the button eight times using a matchstick or similar and the receiver indicator light should blink seven times.
3. Wait five seconds then press button once and receiver indicator light should now be on.
4. Open a door or move the magnet away from transmitter and the receiver indicator light will blink three times.
5. Set the controller timer for one minute. Scan the QR code for fade-in/out delay and timer DIP switch settings.
6. With the controller’s timer set to one minute allow up to 80 seconds to switch off after all doors are closed.